How to solve the deformation problem of plastic products in plastic injection molding factory

Forwa injection molding factory, plastic injection molding process, the deformation of plastic products is a problem that can not be solved, how to solve the deformation of

plastic products? Forwa engineers believe that it can be analyzed from the following aspects

     
      1) When deformation is caused by residual stress caused by molding conditions, stress can be eliminated by reducing the injection pressure, improving the mold and making

the mold temperature uniform and increasing the resin temperature or adopting annealing method.

      2) When the stress and deformation are caused by poor demoulding, it can be solved by increasing the number or area of ejector and setting the demoulding slope.

      3) Due to the improper cooling method, the cooling method can be adjusted and the cooling time can be extended when the cooling method is not uniform or the cooling

time is insufficient. For example, a cooling loop may be located as close to the deformation as possible.

     

 4) For the deformation caused by the forming shrinkage, it is necessary to correct the mold design. Among them, it is important to pay attention to the product wall thickness

is consistent. Sometimes, in case of necessity, it is necessary to correct the mold by measuring the deformation of the product and trimming it in the opposite direction.